Page 1 of Samsung 224 Region 1 Hack

Does anybody have the code for Region 1? I mean intead of code "5 7 5 3 8" I´m looking for the same code but for R1
Thanks in advance

You mean a code to hack the Region 1 (North American) version of the same player? I don`t think there is one.

Starting with the DVD-511, Samsung removed the standard region hack from all North American player firmware versions (but kept it in European, Asian etc. versions). It`s unclear why they did this - possibly to comply with the Digital Millennium Copyright Act, or for some other reason - but the fact remains that the Land of the Free is a hack-free zone as far as Samsung is concerned.

Mike

I have a Samsung DVD-S224, I need to know if there is a Multi-Region hack code.

Hey, did you get a hack to go from region 2 to region 1??? if so would you email it to me..... thanks...

Hope this helps:

TO MAKE YOUR "SAMSUNG DVD-S224" REGION CODE FREE.

*USE YOUR REMOTE FOR THIS PROCESS.

1. Turn DVD player on with no disc inserted.
2. Press "REPEAT" once on your remote control.
3. If your DVD player is:
Region 1 coded type: 2 9 3 3 4
or,
Region 2 coded type: 3 8 7 6 7
or,
Region 3 coded type: 5 6 7 3 2
or,
Region 4 coded type: 7 6 8 8 4
or,
Region 5 coded type: 5 3 8 1 4
or,
Region 6 coded type: 2 4 4 6 2
*So if your dvd player only plays dvd`s that are
region 1 coded you would type 2 9 3 3 4

4. Then press 9 on your remote control.
5. Wait 10 seconds.
6. Turn power off.

*YOUR "SAMSUNG DVD-S224" IS NOW REGION CODE FREE AND
CAN PLAY ANY DVD FROM ANY COUNTRY.

Just a few corrections, Tim:

a) You should wait for the Samsung logo to appear on the screen before you press REPEAT. (There is a slight delay.)

b) For the Samsung DVD-S series players, you should use 5 7 5 3 8 rather than 3 8 7 6 7 in the case of a region 2 machine. (3 8 7 6 7 is for older models.)

c) American (region 1 coded) DVD-S players are not hackable at all via this method. Again, the 2 9 3 3 4 code only applies to older models such as the 709.

d) After pressing 9, you should immediately press OPEN/CLOSE on your remote control (this opens the tray). Then wait 10 seconds, then press POWER.

Mike